#What is sharks 3d software how to#
#What is sharks 3d software manual#
#What is sharks 3d software Pc#
#What is sharks 3d software download#

While printing directly from a PC is possible and might seem more convenient than copying over the files to the micro-SD card and then reattaching the card to the printer, itвЂ™s not as reliable as it requires the PC and the slicing program to stay awake during the entire print.

#What is sharks 3d software how to#

There are lots of good videos which go over how to get your models imported into the software, tweaking the parameters, and then saved and exported as a Gcode file ready for printing. Take your time to familiarize yourself with the program to understand the importance of each setting as it can make a huge difference in terms of quality and print time. Essentially, through a variety of customizable settings, you can instruct the printer how precise, dense and fast to make the print. If youвЂ™re not familiar with this kind of slicing software, it can be a bit overwhelming at first figuring out how to getВ 3D objects ready for pprinting. Now that the printer is fully set up and adjusted, there are two ways to print 3D files and etched images. Seems like there should be aВ simple setting available to avoid this, or just smarter software. Second, and really frustrating, if your first filament on the left is ever out, even if you have the printer set to only print with the second, it will give you an error that your filament is out and it will not allow you to continue until at least a few cm of filament have been pushed through the first sensor so that it can detect it.Д«ecause of this last limitation, with my later prints a few weeks into my review, I had to completely switch the filament out of the second extruder into the first to allow it to print anything. First, I would have liked for the option, if itвЂ™s a single color print, to allow the printer to default to using the second filament if the first runs out. The filament sensor is useful with pausing a print if you run out of filament during it, but it has some limitations. Using theВ dials underneath the bed, the goal is to tighten them each just enough that it creates slight friction at each point when you pull onВ a test piece of paper.

#What is sharks 3d software manual#

If youвЂ™re doing manual leveling, which I recommend, the setup screenВ will have fiveВ points that the extruder will travel to the 4 corners and the 1 center point. Through the on-screen settings menu, there are two leveling setups available, automatic and manual. Underneath the print bed, there are four large dials that can be turned to adjust each of the sidesвЂ™ heights. Something that takes more time figuring outВ isВ leveling. This is another example of where the manual doesnвЂ™t walk you through the process, but IВ did find theirВ short YouTube video to beВ clear enough.

#What is sharks 3d software download#

I would recommend visiting Lotmaxx'sВ support page firstВ to download the latest available firmware, which you can then flash via the included 16GB micro-SD card. Once you actually manage to assemble everything and power on the Lotmaxx SC-10 V2, you can continue with the setup process. A simple problem with a simple fix, but this would be just the first. While it would be nice for the units to ship out with their localized voltage switch pre-configured, I would be more than happy to also have the instructions clearly indicate this crucial step in the right spot.

They too made sure everything was properly installed but couldnвЂ™t get the SC-10 to turn on, and so assumed it arrived broken. With no luck, I began to search for my problem online and found that a few other users experienced the same issue and left 1-star reviews on Amazon. I rechecked every attachment, cable and tried other outlets to see if that was the problem. I ended up trying to figure out why the printer wasnвЂ™t turning on for about 15 minutes.